About
Benefits of the Director OCDC Lawnmower Chute
The Director lawnmower OCDC puts you in control. With a flick of the wrist the Director OCDC can quickly go from the wide-open position to the closed position, increasing safety around people and cars, as well as making it very versatile around flower and shrubbery beds.
The Director flap is easily removed without tools and the upright does not interfere with the use of your vacuum. With 3/8″ thick steel construction on the upright and a 3/16″ steel flap the Director is built to withstand years of daily use. All fabricated steel parts are powder coated semi-gloss black.
The Director OCDC offers many benefits including:
- Grass Blocker
- Designed for eXmark Riding Mowers
- Complete Control of Grass Discharge
Dealer pricing available.
Demonstration of the Director OCDC
Demonstration Video 1: Shows how clippings are contained within several inches of the deck. The Director OCDC lawnmower chute is not a mulch kit. It is designed to control how your clippings are disbursed. The flap does allow clippings to escape in order to keep them from building up under the deck.
Demonstration Video 2: Shows general operation and how easily positions can be changed. This allows the operator to mow with increased control over how debris is discharged, keeping clippings away from mulch beds, sidewalks and driveways, as well as increasing safety around people and cars.
Driveway Video: Shows removal of clippings by using the Director as a blower. When the Director is in the partially open position it creates enough velocity to blow the clippings from driveways and sidewalks.
Control Handle Operation: Demonstrates how the Director’s various positions are selected.
Installation of the Director OCDC
The Director OCDC Lawnmower Chute is installed in five simple steps:
Mower before installation of The Director OCDC.
First step is to completely remove the factory discharge chute.
Cut out the supplied punch template, tape in place and center-punch
for holes. Drill pilot holes and increase size to 1/2″ inch.
Bolt upright in place using supplied hardware. Do not completely tighten
nuts at this point, just tighten enough so that upright does not move.
Hook s-rod to control handle and flap. Insert hinge rod with
rubber flap underneath rod as shown. Slide washer in place
and insert spring clip. Test control handle for operation and
adjust if necessary. Tighten nuts and you are ready to go.
Chute flap is easily removed without tools and upright
does not interfere with the use of a vacuum.
